06-02-2006, 05:39 AM
The CDI unit controls the tachometer and has 2 built-in codes to warn you when something has gone awry.
Tach readout: 0......3000rpm.......0........actual engine speed...... repeat
Throttle position sensor is disconnected or the reading is outside of the normal band.
0......8000rpm.......0.......actual engine speed.... repeat
Fuel level warning system has an open circuit somewhere. Either the level sender is bad, has a bad ground connection, the connector (small green connector under tank on left side of bike) is disconnected, or the bulb itself is blown.
Searchable Key Words: tach tachometer erratic sweep funky strange odd behavior weird hop hang between diagnostic code error
Tach readout: 0......3000rpm.......0........actual engine speed...... repeat
Throttle position sensor is disconnected or the reading is outside of the normal band.
0......8000rpm.......0.......actual engine speed.... repeat
Fuel level warning system has an open circuit somewhere. Either the level sender is bad, has a bad ground connection, the connector (small green connector under tank on left side of bike) is disconnected, or the bulb itself is blown.
Searchable Key Words: tach tachometer erratic sweep funky strange odd behavior weird hop hang between diagnostic code error